Pioneer MJ-D508 - Manual (Page 40)

3-5
4
1
Press the jog dial (ENTER) to select the function.
On the rennote control press enter .
You'll now hear a few seconds of the track before and after the A and B
erase points. The recorder repeats these alternately. To change either
the A or B points:
E Press the A-B button to select one of the points. Each press switches
between the A and B erase points.
® Move the currently selected point backwards or forwards using the
◄◄ and ►► buttons. Each step corresponds to about 1/100th sec.
Each erase point can be adjusted 176 steps either way (almost 2
seconds backwards or forwards from the original point).
❖ The recorder will not allow you to move point A beyond point B.
❖ If the display shows the message Point err while adjusting either
point, move the point in the other direction until the error message
disappears.
[U Repeat steps 1 and 2 until you have the erase points you want.
❖ To abort at this point, press ■ (stop) or EDIT/NO.
Push the jog dial or press ENTER on the remote to
finalize the edit.
The track numbers are automatically updated to reflect the edit.
Undoing a Mistake
Although the MJ-D508 gives you several opportunities to abort an edit if you make a mistake, there will probably still be
times when you complete an edit operation only to find that it wasn't what you had intended. As long as you haven't
updated the UTOC by ejecting the disc or performing a UTOC write command, or recorded anything else on the disc, you can
still undo the last edit operation.
Press EDIT/NO when the disc is stopped.
Turn the jog dial until you see UNDO in the
display.
On the remote control use the and buttons.
❖ If no undo is possible, then the recorder won't give you this option.
Push the jog dial or press ENTER bn the remote.
❖ Cancel the undo operation by pressing ■ (stop) or EDIT/NO.
Input by pushing the jog dial or pressing ENTER
on the remote again.