beautypg.com

How to yse yoyr cook top module, Coil module removal änd replacement, To remove or replace surface unit modules – Kenmore Kitchen Grill User Manual

Page 7: To remove, To replace, Steps, Surface unit removal for cleaning, Surface unit removal

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

how to yse yoyr cook top module

COIL MODULE REMOVAL ÄND REPLACEMENT

Make sure all Surface Unit Control Knobs are in

the “OFF” position and the modules are cool

before removing or replacing.

To remove or replace Surface Unit Modules

1.

To remove:

• Lift module using the handle at the front (See

Step 1 ) Raise front just high enough to grasp at

front edge

• Ease module toward you using both hands to

unplug it (See Step 2 )

• Lift module out of cooktop All modules may be

used in either cooktop position (left or right)

2.

To replace;

• Grasp module with both hands (See Step 2 )

• Ease It into place, align the module terminal with

the receptacle on the cooktop (See Step 3.)

• Lower the module, using the handle on the front

(See Step l )

Step1

Receptacle

Terminai

Step 2

steps

SURFACE UNIT REMOVAL FOR CLEANING

CAUTION: Be sure the switch is turned off and the
element is cool before removing element

The surface units can be unplugged and removed for

easier cleaning of the cooktop

When removing, tilt surface unit upward slightly to clear

reflector bowl and put! away from terminal block Sur­
face unit will not sit level, when replaced, if it is forced
too far upward when removing DO NOT put unit in
water to clean it! It will clean itself when heated during

normal cooking use Lift out the chrome reflector bowls
for cleaning.

Place clean reflector bowls into cooktop making sure

the terminal block is open and showing Slide surface

unit into terminal block and lower into reflector bowl

CAUTION: Do not attempt to operate surface elements unless reflector bowls are in place Failure to do this will

cause scorching of cooktop, burning of wiring insulation and loss of energy