Oven door removal, How to use the oven light switch, Storage drawer (slide-ins) – Kenmore Kitchen Grill User Manual
Page 18: Removable oven racks, Removing oven rack, Cleaning and maintenance features
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
cleaning and maintenance features
OVEN DOOR REMOVAL
Open oven door to first stop
position. Hold the door firmly at
sides, lift up and away from the
range To replace, slip hinge arms
into door slots, and with hand or
knee push door in at bottom until it
clicks Then close door
{for those models with a light)
HOW TO USE THE OVEN LIGHT SWITCH
The oven light can be turned OFF by a control button
located on the right end of the control panel Press in to
turn light on and off
REPLACING THE OVEN LIGHT
(some models)
Do not touch the oven bulb when hot, with wet hands or
wipe oven light area with wet cloth Unscrew the bulb
and replace with a 40 watt, 130 volt appliance bulb An
appliance bulb is smaller than a standard 40 watt
household
bulb
The130voltbulbismadetowithstand
high oven temperatures and gives you a much longer
bulb life A 120 volt bulb may be used, but life
expectancy is much shorter
To change the bulb, on models having a glass lens held
in place with a spring wire to protect the oven bulb frorn
heat
8 Swing the wire all the way to the side and hold it so
glass tens can be lifted off
8 Unscrew bulb and replace with a 40 watt appliance
bulb
8 Place glass lens over socket and swing wire back up
over lens
8 The glass lens must be in place whenever the oven is
in use
STORAGE DRAWER
(slide-ins)
This drawer gives you extra space
cookware and bakeware
Do not keep plastics and flammable materials
drawer
for keeping
in this
REMOVABLE OVEN RACKS
The oven racks can be removed for easy cleaning Pull
the rack out and up. in one motion to remove
Make sure your racks are inserted correctly The
straight racks should have the back bar curved up and
facing the rear of the oven The offset rack (666 Series)
has the offset facing up with the two wire tabs to the
rear
18