beautypg.com

Range end panel removal or installation, Modular ranges, Coil top ranges – Kenmore Kitchen Grill User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

RANGE END PANEL REMOVAL OR INSTALLATION

WARNING - Disconnect electrical power to range before beginning installation

The end panel kit consists of;

Two End Panels (R.H & LH.)

Two End Panel Brackets

Eight Screws

Installation instruction sheet

MODULAR RANGES

TO REMOVE END PANEL:

T

2

4

Remove both modules from range top
From inside of modular opening remove the

screw (circle A)

Remove the two screws from the back of end

panel

Move the end panel out at the rear and slide out

from behind the front trim

FOR BUILT-IN INSTALLATION ONLY;

This type of installation requires that the end panels be

removed (if equipped) and two toe protectors, part no
1325189,

be

installed

(if

not

equipped)

The

toe

protectors are listed in the repair parts book and can be
ordered through the Sears service center

1 Remove end panels as shown above

2, Install toe protectors as shown, using existing

screws on range

^

COIL TOP RANGES

TO REMOVE END PANEL;

1

Raise cooktop and securely support or have it

held, remove screw B

2

Remove the two screws from the back of end

Panel.

3,

Move the end panel out at the rear and slide out

from behind the front trim

FOR BUILT-IN INSTALLATION ONLY:

1

Remove end panels as shown above

2

Install toe protectors as shown, using existing

screws on range

BRACKET ON END PANEL-

FRONT TRIM

INSTALL TOE PROTECTORS

FOR BUILT-IN
INSTALLATION ONLY

TO INSTALL END PANEL:

1

2

.

Attach end panel bracket to end panel with

screw provided.

Position the end panel behind the front trim

and

tight

to

the

underside

of

the

cooktop

frame

Align the two holes in the back of end panel

with

holes

in

range

back

and

attach

with

screws provided.

From

inside

of

modular

opening,

drive

a

screw into bracket. (Circle A)

-B

FRONT TRIM.

INSTALL TOE PROTECTORS

FOR BUILT-IN

INSTALLATION ONLY

Ö»'

TO INSTALL END PANEL:

1,

Remove toe protectors and replace mounting

screws

2 Position the end panel behind the front trim and

tight to the underside of upper side panel.

3.

Align the two holes in the back of end panel with

holes in range back and attach with screws

provided.

4.

Raise cooktop and securely support or have it

held, drive a screw through upper side panel into

end panel.