Backguard attachment instructions – Kenmore Kitchen Grill User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BACKGUARD ATTACHMENT INSTRUCTIONS
WARNING — Disconnect electrical power to range before beginning installation
Adjust the width of the backguard to fit inside the countertop cutout
TO ADJUST WIDTH OF BACKGUARD:
A, Loosen screws holding end caps to back guard supports (Screws
A)
B Slide end caps in or out
C. Retighten screws
TO ATTACH TO RANGE.
FASTEN
THE
BACKGUARD
MOUNTING
BRACKETS
TO
THE UPPER SIDE PANELS, USING EXISTING SCREWS ON
RANGE, (Screws
B)
TO ADJUST THE FRONT TO BACK POSITION OF THE BACKGUARD:
(After attached to range)
A Loosen screws holding backguard to mounting brackets,,
B, Position backguard as desired,
C Retighten screws, (Screws
C)
REMOVE PROTECTIVE COVERING
FROM BACKGUARD PANEL BEFORE
OPERATING RANGE
TO ADJUST END CAP, LOOSEN
SCREWS
A
TO ADJUST BACKGUARD
POSITION, LOOSEN SCREWS
C
SCREWS
B
MOUNTING BRACKET