Prepare your top thread – Kenmore 385.15358 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEWING
machíne
DIV. 20
MODEL 384. 15358
PREPARE YOUR TOP THREAD
FOR THREADING THE MACHINE, FOLLOW THE NUMBERS IN ORDER AS SHOWN
ON THE ILLUSTRATION.
DOTTED LINES SHOW THE PLACES WHERE THE THREAD LOOPS AND THEN
IS PULLED TIGHT.
RAISE THE PRESSER FOOT LEVER.
PLACE A SPOOL ON THE SPOOL PIN, WITH THREAD COMING OFF AS SHOWN.
1. DRAW THREAD THROUGH THE THREAD GUIDE.
2.
HOLDING THREAD TAUT WITH RIGHT HAND, DRAW THREAD DOWN INTO THE
TENSION AREA AND THEN AROUND THE CHECK SPRING HOLDER.
3.
FIRMLY DRAW THREAD UP AND THROUGH THE TAKE-UP LEVER FROM RIGHT
TO LEFT.
4.
DRAW THREAD DOWN AGAIN AND SLIP IT INTO THE NEEDLE BAR THREAD
GUIDE.
5. TREAD NEEDLE FROM FRONT TO BACK.
NOTE; YOU MAY WANT TO CUT THE END OF THREAD WITH SHARP SCISSORS
FOR EASIER NEEDLE THREADING.