To check, Adjustment procedure, Mechanical adjustment – Kenmore 385.15358 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEWING
machíne
DIV. 20
MODEL 384. 15358
MECHANICAL ADJUSTMENT
FEED DOG HEIGHT
MACHINE SETTING
1.
STITCH SELECTOR;" i c b "
2.
NEEDLE BAR:
AT ITS HIGHEST POSITION.
TO CHECK:
1.
RAISE THE PRESSER FOOT.
2.
PLACE THE FEED DOG HEIGHT GAUGE #68367 "A" ON THE NEEDLE
PLATE.
3.
TURN THE HANDWHEEL TOWARD YOU BY HAND AND CHECK THE FEED DOG
HEIGHT. REFER TO CHART BELOW.
ADJUSTMENT PROCEDURE:
1.
OPEN THE SHUTTLE COVER. LOOSEN THE SCREW (A).
2.
ADJUST THE FEED DOG HEIGHT BY TURNING THE FEED LIFTING PIN.
*
WHEN THE FEED DOG HEIGHT IS HIGHER THAN THE STANDARD RANGE, TURNS
THE FEED LIFTING PIN IN THE DIRECTION OF "B".
*
WHEN THE FEED DOG HEIGHT IS LOWER THAN THE STANDARD RANGE, TURN
THE FEED LIFTING PIN IN THE DIRECTION OF "C".
GAUGE
FEED DOG HEIGHT
FACE (A)
FACE (B) (RED)
1.25 MM
1.00 MM
NOT MOVING
MOVING
CORRECT
NOT MOVING
NOT MOVING
LOW
MOVING
MOVING
HIGH
IS