beautypg.com

To remove, To attach, To adjust the position of the threader plate (c) – Kenmore 385.15358 User Manual

Page 29: Mechanical adjustment

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SEWING

machíne

DIV. 20

MODEL 384. 15358

TO REPLACE NEEDLE THREADER PLATE

TO REMOVE

1. REMOVE THE FOOT HOLDER.

2.

PULL OUT THE THREADER PLATE UNIT (A).

TO ATTACH

3.

PUSH THE THREADER PLATE UNIT (A) UP TO SNAP IT WITH THE PIN (B) AS SHOWN

IN FIG.1.

4. ATTACH THE FOOT HOLDER.

TO ADJUST THE POSITION OF THE THREADER PLATE (C)

IF THE THREADER PLATE IS SLIGHLY OUT OF ALIGNMENT, LOOSEN THE SETSCREW

(D) AND ADJUST THE POSITION AS SHOWN IN FIG.2.

IF THE ABOVE WAY OF ADJUSTMENT IS NOT APPLICABLE, MAKE THE ADJUSTMENT AS

SHOWN IN FIG. 3 AS FOLLOWS:

1.

OPEN THE FACE PLATE.

2. WHEN THE THREADER PLATE IS:

TOO HIGH, LOOSEN THE HAXAGONAL SOCKET SCREW

(E)

AND LOWER THE

SETTING PLATE (F).

TOO LOW, LOOSEN THE HEXAGONAL SOCKET SCREW (E) AND RAISE THE

SETTING PLATE (F).

3. TIGHTEN THE HEXAGONAL SOCKET SCREW (E).

MECHANICAL ADJUSTMENT

27