Steps, Check ignition of surface burners, Step 6 – Kenmore 362.7562 User Manual
Page 44: Check ignition of oven burner, Step 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS (continued)
STEPS
Check Ignition of Surface Burners
Operation of all cooktop and oven burners should be
checked after the range and gas supply lines have been
carefully checked for leaks.
Select a top burner knob and simultaneously push in and
turn to LITE position. You will hear a snapping sound
indicating proper operation of the spark module. Once the
air has been purged from the supply lines, burners should
light within 4 seconds. After burner lights, rotate knob out
of the LITE position. Try each burner in succession until
ail burners have been checked.
Quality of Flames
The combustion quality of burner flames needs to be
determined visually.
(A) Yellow flames—Call
Sears for service
(B) Yellow tips on outer
cones—Normal for
LP gas
A A A A fli A A A A'
■IIIIIIIIM
IIIIIIIII
(C) Soft blue flames—
Normal for natural gas
If burner flames look like (A), call Sears for service.
Normal burner flames should look like (B) or (C),
depending on the type of gas you use.
With LP gas, some yellow tipping on outer cones is
normal.
STEP 6
Check ignition of Oven Burner
The oven is designed to operate quietly and
automaticaliy. To operate the oven, press the BAKE pad
and then press the number pads until 350° appears in the
display. Press the START pad. After 30-90 seconds, the
oven burner will ignite and burn until the set temperature
is reached. The oven burner will continue to cycle on and
off as necessary to maintain the oven at the temperature
indicated by the display.
To check ignition of the broil burner, press the BROIL HI/LO
pad and then the START pad. After 30-90 seconds, the
broil burner will ignite.
Electronic ignition models require electrical power to
operate In case of a power outage, the oven burners
on these models cannot be lit manually with a match..
Gas will not flow unless the glow bar is hot.
If the oven is in use when a power outage occurs, the
oven burner will shut off and cannot be re-lit until power
is restored.
STEP 7
Adjust Broil and Oven Burner Air
Adjustment Shutters If Necessary
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flames.
The air adjustment shutter for the top (broil) burner is in
the center of the rear wall of the oven.
44