beautypg.com

Cariandc|»im, Sealed burner assemblies, Burner heads – Kenmore 362.7562 User Manual

Page 31: Burner caps, Caution, Small, Large

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CARiANDC|»iM

Proper care and cleaning are important so your range will

give you efficient and satisfactory service, Follow these
directions carefully in caring for it to help assure safe and
proper maintenance.,

BE SURE ELECTRICAL POWER IS DISCONNECTED
BEFORE CLEANING ANY PART OF YOUR RANGE.

Sealed Burner Assemblies

CAUTION

: DO NOT OPERATE THE

COOKTOP WITHOUT ALL BURNER PARTS AND
DRIP PANS IN PLACE.

Turn all controls off before removing burner parts

and drip pans.

The burner grates, caps, heads and drip pans can be
lifted off, making them easy to clean.

Lift off burner parts for cleaning when they are cool.

\

Elecirode

CAUTION:

The electrode of the

spark igniter is exposed
when the burner head
is removed. When one
burner is turned to LITE, ali the burners spark.

Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to knock
over hot cookware.

Burner Heads

NOTE: Before removing the burner heads and caps,
remember their size and location. Replace them in

the same location after cleaning.

For proper ignition, make
sure the small hole in the
section that fits over the
electrode is kept open.
A sewing needle or bare
wire works well to
unclog it-

The slits in the burner heads of your range must be

kept clean at all times for an even, unhampered flame.

You should clean the surface burners routinely, especially

after bad spillovers, which could clog these openings.

To remove burned-on food, soak the burner heads in a

solution of mild liquid detergent and hot water for 20-30
minutes. For more stubborn stains, use a toothbrush.

Before putting the burner head back, shake out excess
water and then dry it thoroughly by setting it in a warm
oven for 30 minutes.

Replace the burner heads

and caps. Make sure that
the heads and caps are

replaced in the correct
location. There is one
small, 2 medium and
one large cap.

NOTE: Do not use steel
wool or scouring powders
to clean the burners.

After cleaning, make sure the slot

in the burner head is positioned

over the elecirode

Burner Caps

Lift off when cool. Wash burner caps in hot, soapy water
and rinse with dean water. You may scour with a plastic
scouring pad to remove burned-on food particles-

Dry caps in a warm oven or with a cloth—doni reassemble
them wet- Replace the caps back onto the burner heads.

Small

Medium

Large

31

Make sure that caps are replaced on the correct size
burner There is one small, 2 medium and one large cap.
Sizes are marked on the bottom of medium and large caps.

This manual is related to the following products: