beautypg.com

Step 4, Seal the openings, Caution – Kenmore 362.7562 User Manual

Page 43: Temporary method

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

A: Usage Situations Where Appliance Power Cord
Will Be Disconnected Infrequently.

TEMPORARY METHOD

An adapter may be used only on a 15-amp circuit. Do not
use an adapter on a 20-amp circuit. Where local codes
permit, a TEMPORARY CONNECTION may be made to

a properly grounded two-prong wall receptacle by the use
of a UL-listed adapter, available at most hardware stores.

The larger slot in the adapter must be aligned with the

larger slot in the wall receptacle to provide proper polarity
in the connection of the power cord.

CAUTION

I Attaching the adapter ground

terminal to the wall receptacle cover screw does not
ground the appliance unless the cover screw is metal,

and not insulated, and the wall receptacle is grounded
through the house wiring. The customer should have
the circuit checked by a qualified electrician to make
sure the receptacle is properly grounded.

When disconnecting the power cord from the adapter,
always hold the adapter with one hand. If this is not done,
the adapter ground terminal is very likely to break with

repeated use. Should this happen, DO NOT USE the
appliance until a proper ground has again been
established.

B: Usage Situations Where Appliance Power Cord
Will Be Disconnected Frequently.

Do not use an adapter plug in these situations because

disconnecting of the power cord places undue strain on
the adapter and leads to eventual failure of the adapter
ground terminal. The customer should have the two-prong
wall receptacle replaced with a three-prong (grounding)

receptacle by a qualified electrician before using the

appliance.

The installation of appliances designed for mobile home

installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or,

when such standard is not applicable, the Standard for

Manufactured Home Installations, latest edition
(Manufactured Home Sites, Communities and Set-Ups),
ANSI A225.1, latest edition, or with local codes. In
Canada, mobile home installation must be in accordance
with the current CAN/CSA Z240/M1I Mobile Home

Installation Code.

Electric Disconnect Plug

This plug allows you to conveniently disconnect the range
from electrical power.

1. Locate disconnect plug on the range back.

2, Pinch sides of connector and pull out of range back.

STEP 4
Seal the Openings

Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.

43

This manual is related to the following products: