How to set the oven for cleaning, To stop a clean cycle, After a clean cycle – Kenmore 362.7562 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How to Set the Oven for Cleaning
If the oven is too hot and you start to set a clean cycle,
you will not be able to slide the latch.
Allow additional time for cooling before you try to set
the cycle,
1. Follow directions in the Before a Clean Cycle section,
2. Slide the latch handle to the
right as far as it will go.
Never force the latch
handle. Forcing the handle
will damage the door lock
mechanism.
3. Press the SELF CLEAN pad
4. Press the A or ▼ pads until the
desired Clean Time is displayed.
The Clean Time is normally 4 hours
and 20 minutes. You can change
the Clean Time to any time
between 3 and 5 hours, depending
on the amount of soil in your oven.
5. Press the START pad.
The seif-ciean cycle will automatically begin after
CLEAN is displayed and the time countdown appears
in the display.
While the oven is self-cleaning, you can press the
CLOCK pad to display the time of day. To return to the
clean countdown, press the SELF CLEAN pad.
The oven shuts off automatically when the clean cycle is
complete, and 0:00 will flash in the display.
6. Slide the latch handle to the left as far as it will go and
open the door.
To Stop A Clean Cycle
Press the STOP/CLEAR pad
Wait until the oven has cooled below the locking
temperature to unlatch the door. You will not be able to
open the door right away unless the oven has cooled
below the locking temperature.
After a Clean Cycle
You cannot set the oven for cooking until the oven is cool
enough for the door to be unlatched.
You may notice some white ash In the oven. Wipe it up
with a damp cloth after the oven coots.
If white spots remain, remove them with a soap-filled
scouring pad and rinse thoroughly with a vinegar and
water mixture.
These deposits are usually a salt residue that cannot be
removed by the clean cycle.
If the oven is not clean after one clean cycle, repeat
the cycle.
« You cannot set the oven for cooking until the oven is
cool enough for the door to unlock.
• While the oven is self-cleaning, you can press the
CLOCK pad to display the time of day. To return to the
clean count down, press the COOKING TIME pad.
• If the shelves become hard to slide, apply a small
amount of vegetable oil or cooking oil to a paper towel
and wipe the edges of the oven shelves with the
paper towel.
29