Kenmore 3405594 - Manual (Page 33)

REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and will Increase your satisfaction
with your Kenmore laundry center.
□ Check electrical requirements. □ Check that the laundry center
Be sure you have correct electrical is level,
supply and recommended grounding r-, ,
method ^ Check that the water faucets are
' turned on.
n Check that you have: ^ ^ ... .
n Ensure that laundry center
IS
. All the tools you started with. positioned in its final location. Make
• Removed all packaging materials. sure vent is not crushed or kinked.
• Installed ail parts listed on
pages 6-12.
FINAL STEPS
□ Plug the power supply cord into
the grounded outlet or power supply.
□ Turn power supply on.
□ Wipe the interior of the dryer drum
thoroughly with a damp cloth to
remove any dust.
□ Remove the blue protective film on
the console and any tape remaining
on laundry center.
□ Take a few minutes and read the
Operating Instructions (pages 34-43)
to fully understand your new laundry
center.
□ Start the washer and allow it to
complete the HEAVY DUTY Cycle.
□ To remove air from the gas line, set the
dryer on a full heat cycle (not the AIR
DRY cycle) for 20 minutes. After five
minutes, open dryer door. The burner
should have ignited during these five
minutes. If you do not fee! heat, turn
the dryer off and WAIT 5 MINUTES.
During these 5 minutes check to be
sure laundry center gas supply valve is
open. Repeat steps above. If the burner
still does not ignite, see Troubleshooting
information on pages 58-59.
33