C. remove styrofoam packing – Kenmore 3405594 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To install rear legs:

STEP 1. if you have not already done
so> lay the laundry center on its side.

Because of the weight of the laundry

center, two people should lay it down.

STEP 2. Push legs into holes in rear
corners until they snap into place.

B. INSTALL LEVELING LEGS

STEP 3. Check adjustability of rear legs,
by pushing in one leg. The other leg

should come out. Check both legs.

If they do not adjust, repeat STEP 2.

To install front legs:

STEP 1. Screw front legs Into the holes

In the triangular braces In front corners.

Screw them in with an adjustable wrench

to the diamond marks on the ridges.

STEP 2. Carefully stand the laundry

center upright. Because of the weight
of the laundry center, two people
should lift it.

C. REMOVE STYROFOAM

PACKING

To prevent floor damage, set laundry
center onto cardboard before moving
across floor.

Move laundry center close to its final
location.

STEP 1. Open the washer lid. The latch
under the dryer will keep the lid open.

Read, then remove the yellow card on

the agitator.

STEP 2. Pull the styrofoam packing out
of the washer.