Kenmore 106.511800 - Manual (Page 28)

A WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
Is the ice dispenser stalling while dispensing “crushed” ice?
Change the ice button from “crushed” to “cubed.” If cubed
ice dispenses correctly, depress the button for “crushed” ice
and begin dispensing again.
Has the dispenser arm been held in too long? Ice will stop
dispensing when the arm is held in too long. Wait 3 minutes
for dispenser motor to reset before using again.
The water dispenser will not operate properly
Freezer door closed completely? Close the door firmly. If it
does not close completely, see “The doors will not close
completely.”
Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
Is the water pressure at least 30 psi (207 kPa)? The water
pressure to the home determines the flow from the dispenser.
See “Water Supply Requirements.”
Kink in the home water source line? Straighten the water
source line.
New installation? Flush and fill the water system.
Water filter installed on the refrigerator? The filter may be
clogged or incorrectly installed.
Is a reverse osmosis water filtration system connected to
your cold water supply? See “Water Supply Requirements.”
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
■ Glass not being held under the dispenser long enough? Hold
the glass under the dispenser for 2 to 3 seconds after
releasing the dispenser lever/pad.
■ New installation? Flush the water system. See “Prepare the
Water System” or “Water and Ice Dispensers.”
■ Recently changed water filter? Flush the water system. See
“Prepare the Water System” or “Water and Ice Dispensers.”
The dispenser water is not cooi enough (on some modeis)
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
■ New installation? Allow 24 hours after installation for the
water supply to cool completely.
Recently dispensed large amount of water? Allow 24 hours
for water supply to cool completely.
Water not been recently dispensed? The first glass of water
may not be cool. Discard the first glass of water.
Refrigerator connected to a cold water pipe? Make sure the
refrigerator is connected to a cold water pipe. See “Water
Supply Requirements.”
ACCESSORIES
Replacement Parts:
To order stainless steel cleaner or replacement filters, call
1-800-4-MY-HOME® and ask for the appropriate part number
listed below or contact your authorized Kenmore dealer.
Stainless Steel Cleaner and Polish:
Order Part #D22 M40083 R
Water Filter:
Order Part #9930 (P4RFWB)
Air Filter:
Order Part #W10335147A
Produce Preserver:
Order Part #W10335145A
WATER FILTER
CERTIFICATIONS
State of California
Department of Publie Health
Water Treatment Device
Certificate Number
10-2030
Date issued: febniary 26, 2010
Trademark/.Modei Designation ; „ Replacement Elements
P5WB2L : . . P4RTWB
Manufacturer: Whirlpool Corporation
The water treatment device{s) listed on this certificate have met the testing requirements pursuant to Section
116830 of the Health and Safet>' Code for the following health related contaminants:
Microbiologicai Contaminants and I'urbiditv
Cysts • .
Oraanic Contaminants
Atraziue -, -
Lindane , ‘ . '
Toxaphene v, ,
2,4-D
Inorganic/RadioJosicai Contaminants
Asbestos i......... , '
Lead
Rated Service Capacit>: 200 gai Rated Service Flow: 0.5 gpm
Conditions of Certification:
Do not use where water is microbioiogicallv unsafe or with water ot unknown quaiitv, except that systems certified
for cyst reduction may be used on disinketed \s aleis ihal mav umtain filterable e\ sis
28