Kenmore ELITE 795.7104 User Manual
Kenmore elite
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Use & Care Guide
Manual de Uso y Cuidado
Guide d’utilisation et d’Entretien
English / Español / Fronçais
Models/Modelos/Modèles: 795.7104*
Kenmore Elite.
* :.. color number, número de color, le numero de lo couleur
P/N MFL62184411
Sears Brands Management Corporation
Hoffman Estates, IL 60179 U.S.A.
Sears Canada Inc.
Toronto, Ontario, Canada MSB 2B8
Table of contents
Document Outline
- Use & Care Guide
- Manual de Uso y Cuidado Guide d’utilisation et d’Entretien
- TABLE OF CONTENTS
- PROTECTION AGREEMENTS
- Master Protection Agreements
- PRODUCT RECORD
- PARTS AND FEATURES
- Excessive Weight Hazard
- UNPACKING YOUR REFRIGERATOR
- INSTALLATION
- PRIOR TO USE
- HOW TO REMOVE DOOR HANDLES
- HOW TO REPLACE DOOR HANDLES
- REMOVING AND REPLACING REFRIGERATOR DOORS
- HOW TO REMOVE AND INSTALL THE FREEZER DRAWER
- 1. Removing Freezer Drawer
- HOW TO REMOVE AND INSTALL THE FREEZER DRAWER (coni)
- 2. Installing Freezer Drawer
- LEVELING AND DOOR ALIGNMENT Leveling
- SETTING THE CONTROLS
- ADJUSTING CONTROL SETTINGS
- FOOD STORAGE GUIDE
- STORING FROZEN FOOD
- REFRIGERATOR SHELVES
- HUMIDITY CONTROLLED CRISPER
- REMOVING HUMIDITY CONTROLLED CRISPER
- MODULAR DOOR BIN
- DAIRY BIN
- FREEZER SECTION
- ICE BIN
- DURABASE
- PULLOUT DRAWER
- INSIDE WALLS (allow freezer to warm up so the cloth will not stick)
- DOOR LINERS AND GASKETS
- GENERAL CLEANING TIPS
- PLASTIC PARTS (covers and panels)
- CONDENSER COILS
- OUTSIDE
- LIGHT BULB REPLACEMENT
- POWER INTERRUPTIONS
- WHEN YOU GO ON VACATION
- WHEN YOU MOVE
- OPERATION INSTRUCTIONS
- A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
- WHEN YOU SHOULD SET THE ICEMAKER POWER SWITCH TO OFF (O)
- NORMAL SOUNDS YOU MAY HEAR
- PREPARING FOR VACATION
- BEFORE YOU BEGIN
- WHAT YOU WILL NEED
- INSTALLATION INSTRUCTIONS
- 1. SHUT OFF THE MAIN WATER SUPPLY
- 2. CHOOSE THE VALVE LOCATION
- 3. DRILL THE HOLE FOR THE VALVE
- 4. FASTEN THE SHUTOFF VALVE
- 5. TIGHTEN THE PIPE CLAMP
- 6. ROUTE THE TUBING
- 7. CONNECT THE TUBING TO THE VALVE
- 8. FLUSH OUT THE TUBING
- 9. CONNECT THE TUBING TO THE REFRIGERATOR
- 10. TURN THE WATER ON AT THE SHUTOFF VALVE
- 11. PLUG IN THE REFRIGERATOR
- 12. START THE ICEMAKER
- UNDERSTANDING SOUNDS YOU MAY HEAR
- REFRIGERATOR DOES NOT OPERATE
- LIGHTS DO NOT WORK
- VIBRATION OR RATTLING NOISE
- COMPRESSOR MOTOR SEEMS TO RUN TOO MUCH
- DOORS WILL NOT CLOSE COMPLETELY
- FROST OR ICE CRYSTALS ON FROZEN FOOD
- ICE HAS BAD TASTE OR ODOR
- THERE IS WATER IN THE DEFROST DRAIN PAN
- THE REFRIGERATOR SEEMS TO MAKE TOO MUCH NOISE
- THE ICEMAKER IS NOT PRODUCING ICE
- THE DOORS ARE DIFFICULT TO OPEN
- Get it fixed, at your home or ours!