Carl Goldberg GPMA0955 EAGLE 2 - Manual (Page 8)

7
Trailing Edge
Stab Tip
Leading Edge
Trailing Edge Joiner
Center Platform
Leading Edge Joiner
3. Make stab leading edge (LE.) from 1/4" x
1/2" balsa sticks. Cut balsa carefully to
match with plan at center joint.
Pin in position and glue to L.E. Joiner.
Make stab T.E. from 1/4" x 1/2" balsa. Cut to
match length shown on plan and glue to
T.E. joiner.
Complete stab outline by gluing die-cut
balsa stab tips in place.
TAIL ASSEMBLY
1.
Set your flat warp-free pinning board on
work bench.
Tape Eagle plan so stabilizer (stab) is in
position over pinning board.
Tape a sheet of wax paper or plastic
kitchen wrap over stab area to prevent
gluing parts to the plan as you build.
2.
Carefully position die-cut leading and
trailing edge joiners and center platform
and pin in place over the plan. Glue these
parts together using Super Jet (Thick
C.A.).
4.
From 1/8" x 1/4" strip balsa, cut all trusses to
size over plan. Working one-at-a-time, trim to
fit well -don't force into place. Glue in place.
Jet set makes all brands of CA glue dry faster. Use
Jet Set on corner joints for extra-strong fillets.
Glue gussets in place.
Let dry thoroughly.