beautypg.com

Carl Goldberg GPMA0955 EAGLE 2 User Manual

Page 20

background image

19

30.

Glue one end of 2½" wide nylon fabric to scrap wood.
Let dry until the nylon is glued solidly to the balsa.

31.

Apply a line of SUPER JET at center joint on wing bot-
tom and stick one end of 2½" wide nylon to it. Let dry
until the nylon is glued solidly to the balsa.

28.

Lightly sand plastic wing tips to remove burrs from pre-
cut edges. TEMPORARILY fit tips in place (they are per-
manently installed after wing is covered as shown on
page 39). If they bind at T.E., try gently forcing them on,
or sand a slight recess for them in T.E.

29.

Using 240 grit (fine) sandpaper, flat sand entire wing to
blend surfaces and remove high spots.

Cut 1" x 6" half-hard aluminum sheet into 3" pieces
Lightly sand aluminum surfaces for better gluing. Apply
a bead of SUPER JET to half of a 3" aluminum sheet
and glue it to wing T.E. as shown. When dry, apply
glue to other halt and then wrap it around T.E. Repeat
for other 3" piece.

32.

Apply a squiggle of glue to wing and pull nylon fabric
into it. Rub nylon into glue with your finger (cover finger
with plastic bag or similar).