Carl Goldberg GPMA0955 EAGLE 2 - Manual (Page 26)

25
12 b. Tape hatch supports to both sides.
13. Position taped parts in place on fuse. Because of curva-
ture, the hatch supports can overhang the sides slightly
(the overhang to be sanded off later.) Glue only the
hatch supports to the body sides.
14. Remove hatch cover from fuse. Refer to plan for correct
placement of ply tongue, then glue tongue to hatch
cover. Try in place.
Glue dashboard top to hatch supports and dashboard.
15. Place the landing gear (L.G.) mount on inside bottom of
fuse. The cutouts at each end of mount must be posi-
tioned evenly over the slot in the fuse bottom, Glue
mount in place.
16. The L.G. braces interlock with L.G. mount. Glue braces
solidly to fuse sides and L.G. mount.