Braeburn 6400 User Manual - Manual (Page 28)

User Manual 28
Programmable Fan Mode
Programmable Fan Mode is selected by touching FAN until
PROG appears below the FAN TouchPad TM . It is only available in
programmable mode.
Programmable Fan Mode allows the user to run the fan
continuously during a selected program event. To use this feature,
select fan ON while setting program events. (See “Setting Your
Program Schedule”, page 12).
The Programmable Fan Mode is not available if the Circulating
Fan Lock was enabled in the Installer Settings or if in
non-programmable mode (See Installer Manual).
Compressor Protection
Compressor protection is enabled/disabled in the Installer Settings (See Installer Manual). If enabled, this
feature is automatically present in cooling and/or heating modes.
This thermostat includes an automatic compressor protection delay to avoid potential damage to your system
from short cycling. This feature activates a short delay after turning off the system compressor.
Additionally, for multi-stage heat pump systems, this thermostat provides cold weather compressor protection by
locking out the compressor stage(s) of heating for a period of time after a power outage greater than 60 minutes.
This cold weather compressor protection can be manually overridden at any time by changing the system mode
to OFF momentarily, then back to HEAT.