AvMap GEOSAT 4 TRUCK - Manual (Page 19)

1
5.2 Blocking roads
When calculating a route, the Geosat allows
you to avoid some roads or parts of roads. A
road can be blocked even if there is no route
set.
How to block a road:
1. Place the cursor on the road to be
blocked.
2. Press the MENU button. The Navigation
menu will now open.
3. Select Advanced options and press the
ENT button to confirm.
4. The Advanced route-planning menu will
now open. From Blocked roads select
Set blocked road on cursor and press the
ENT button to confirm. The Geosat will
calculate the route. The blocked road will
be shown on the map with two red and
white icons linked by a red line.
How to remove a block from a road:
1. Place the cursor on the blocked road.
2. Press the MENU button. The Navigation
menu will now open.
3. Select Advanced options and press the
ENT button to confirm.
4. The Advanced route-planning menu will
now open. From Blocked roads select
Remove blocked road on cursor and press
the ENT button to confirm. If more than
one road has been blocked, you can select
Remove all blocked roads and press the
ENT button to confirm.
5.3 Reaching Walkways (Pedestrian
areas)
If the destination is a walkway, a window will
warn you that the street is not accessible. In
this case you can choose to activate the walk-
way or to go to the nearest accessible road.
1. Select, with the JOYSTICK, Enable
walkways or Use closest road.
2. Press the ENT button to confirm.