Compaq Presario 7360 - Manual (Page 175)

14-44 Safety and Comfort
Precautions for Products with Laser Devices
All Compaq systems equipped with a laser device comply with safety standards,
including International Electrotechnical Commission (IEC) 825. With specific
regard to the laser, the equipment complies with laser product performance
standards set by government agencies for a Class 1 laser product. The product does
not emit hazardous light; the beam is totally enclosed during all modes of customer
operation and maintenance.
•
Laser Safety Warnings
In addition to the general precautions described earlier in this section, be sure
to observe the following warnings when operating a product equipped with a
laser device. Failure to observe these warnings could result in fire, bodily
injury, and damage to the equipment.
a
WARNING: To reduce the risk of exposure to hazardous radiation:
•
Do not try to open the unit enclosure. There are no user-serviceable components
inside.
•
Do not operate controls, make adjustments, or perform procedures to the laser
device other than those specified herein.
•
Allow only Compaq Authorized Service technicians to repair the unit.
•
Compliance with CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and
Drug Administration implemented regulations for laser products on August 2,
1976. These regulations apply to laser products manufactured from August 1,
1976. Compliance is mandatory for products marketed in the United States.
•
Compliance with International Regulations
All Compaq systems equipped with a laser device comply with appropriate
safety standards including IEC 825 and IEC 950.