ALTANA LCM IV - Manual (Page 31)

32
Standard programs
5.2.5 Sound settings
1. Press Sound Settings in "Instrument Setup".
The following options will be displayed:
•
All: Activates/deactivates a sound with a variable volume for
every function, with the exception of the timer.
• Touch screen: Activates/deactivates a short sound with
variable volume every time the screen is touched.
• Reading done: Activates/deactivates a short sound with
variable volume when the reading is done.
• Timer: Sets short/long sound with variable volume when
timer has ended.
• Startup: Activates/deactivates a startup melody with variable
volume when the test program is started.
• Warning: Activates/deactivates a short sound with variable
volume if there is an error message.
• Shutdown: Activates/deactivates a short sound with variable
volume when shutting down.
2. Select the required action.
3. Press Setup and complete the required settings.
4. Press OK to confirm the entry.
5. Press OK to confirm the entry.
The instrument then returns to "Instrument Setup".
5.2.6 PC and printer
As standard, the instrument has one Ethernet port and 2 USB
ports on the rear of the instrument, as well as one USB port on
the front (see Figure 1 and Figure 2, page 15 ). These interfaces
can be used for exporting data and graphics to a printer, updating
data and transferring data to a PC and in a network. They are
intended for connecting a USB memory, an external USB keypad
or a USB barcode hand-held scanner.
Note: With a USB hub, you can connect various accessory instruments
at the same time.
A USB memory stick is used to update data, refer to
section 6.1.2, page 87 .
Note: A shielded USB cable must not be longer than 3 m!