ALTANA Micro-Gloss Manual - Manual (Page 35)

34
Geometry/Sensor
Combi
When changing the substrate, the sensor will be
switched over automatically
Choose the desired sensor with the scroll wheel.
Press mode to confirm the desired selection.
The selected sensor is indicated in the display.
Note:
The measurement unit can be selected in µm or mil
for display (see section Calibration: Scale
Thickness).
8.3 Sensor-setting Combi
When switching the Thickness setting to Combi,
the measurement will be run through in the
sequence Fe - NFe.
As the measurement takes place on a
ferromagnetic substrate, the procedure will be
finished directly after the Fe measurement.
With the measurement on a non-magnetic substrate
the sequence will go through and therefore lasts
somewhat longer.
Note:
When STATISTICS is activated, all film thickness
values are stored in the Memory independently of
the sonde used.
In the case of an incorrect substrate or a high film
thickness, „Infi“ is written to the memory.
When the instrument is switched off, the last setting
remains active