ALTANA Micro-Gloss Manual - Manual (Page 21)

20
Calibrate
A warning message appears. You can cancel this
process by pressing the operate button.
If you press the scroll wheel, you will continue with
the process of changing calibration values.
In the next display you can enter new calibration
values.
After you have entered the new value, a warning
message appears again in the display. You can
again abort the process with operate.
If you confirm the new value by pressing the scroll
wheel, the value will be accepted.
After you have changed all necessary values, you
should recalibrate the measurement device as
usual.
5.2.4 Status
This menu item provides you with information on the
calibration status of the unit.
In particular, you can check here whether the saved
calibration values match those of the holder. The
display also indicates if an error message was
generated as a result of the last autodiagnosis or
calibration. If this has happened, further information
is available under Section Errors and warning
messages.