A&D Weighing AD-4406 - Manual (Page 23)

AD-4406 Weighing Indicator Page 21
6. 6. 6. 6.
Functions
Functions Functions Functions
There are two parameter lists, one for the F-functions and one for CF-functions. These
functions control the indicator. The parameters of each function are stored in non-
volatile memory, and are not lost even if power is turned off.
F-functions: These parameters can always be changed and are used for
internal settings.
CF-functions: If you accept a certificated approval of the weighing instrument,
the CAL cover must be sealed. Therefore, accepting this
approval, the parameters of the CF-function can not be changed.
6.1. 6.1. 6.1. 6.1. Changing the Function Settings Changing the Function Settings Changing the Function Settings Changing the Function Settings
To enter the function settings, do either of the following.
1 When the display is off, press the ON/OFF key while pressing the +/- key.
2 When in weighing mode, press both the F1 and F2 keys at the same time.
When you are in the function setting, F00 will be displayed.
Operating Item
Step 1 Select an item using the following keys.
key ...... To select a digit.
key ...... To select a value.
ENTER key . To display a parameter of the
selected item.
Proceed to step 2.
ESC key ...... To end setting the functions and
enter the weighing mode.
CAL key ...... To exchange F-functions and CF-
functions.
Operating Parameter
Step 2 Select a parameter using the following keys.
key ...... To select a digit or a sub item
(Type 2 or Type 3).
key ...... To select a value or condition
ENTER key . To store a parameter and proceed to
step 1.
ESC key ...... To proceed to step 1 without
changing the parameter.
Display off
Press the ON/OFF key to turn the display off. This stores the changes.
6. Functions
+/ +/ +/ +/- -- -
F 2
ENTER
F 1
ESC
Weighing
Weighing
ZERO TARE
ZERO TARE
F 2
ENTER
F 2
ENTER
F 1
ESC