KEYENCE LR-ZBxxB - Manual (Page 2)

2 LR-ZB*B Series_IM_E
„ Installation „ Output configuration (L.ON ↔ D.ON)
„ Sensitivity adjustment
Basic Operation
„ Part names and functions „ Package contents
• UP
• L.ON/D.ON • DOWN
• MODE
Calibration
DTM: This lights up when datum
calibration is performed.
1 spot: This turns off when no light enters
or multiple reflections occur.
• Sensor • Certification and
Identification
Label
• Instruction manual
A connector cap is supplied with a
connector.
OK NG Tightening
torque: 0.6 Nm
or less
M18 Tightening torque:
20 Nm or less
24.1 mm
ø3.2
3 mm or less
Direction of installation
„ Wiring
2 1
3 4
1 : 10 to 30 V
2 : OUT (NPN)
3 : 0 V
4 : OUT (PNP)
M12 Connector tightening torque: 0.8 Nm
* Tighten the connector by a hand, and then retighten
it by using tools and so on. Insufficient tightening
will degrade water-resistant performance.
L.ON
1 (Detection
Status)
> 3s
2
D.ON
3s
(Detection Status)
.QP &QP
Output at the time
of D.ON
Output at the time
of L.ON ON
OFF
ON
OFF
Operation
z Basic setting (high accuracy)
(2-point calibration, background
suppression - BGS)
z When an object other than the
background is to be detected
(Datum calibration, foreground
suppression - FGS)
z When an object located nearer
than the background is to be
detected (Maximum sensitivity
calibration, background
suppression - BGS)
z Moving target calibration
(Full auto calibration,
background suppression - BGS)
z Manual adjustment
When the difference
is too small
Press again
< 1s
1
2
Setting value
or NG OK
Press briefly
< 1s
Completed
Setting value -A
1
2
Setting value A
or NG OK
When the 1 spot
indicator light is off
Press and
hold
> 3s
Press briefly
< 1s
Release the button when [ 5'6] flashes
Completed
DTM
OK
Press and
hold
> 3s
Setting value
Completed
Release the button when [ 5'6] flashes
1
Let the detected object pass with
the button pressed until [
5'6]
flashes.
1
Press and
hold
> 3s
Setting
value
OK
* This function cannot be used when
the background is not within
the detecting area.
Completed
Adjust
sensitivity
1
(Run Mode)
2
-99 to 999
(Run Mode) Press briefly
< 1s
3s
Completed