Hardy Enviro Bench Scales - Manual (Page 31)

Section 7: Operations
12/09 26 0596-0315-01 Rev B
2. Weight on the scale must now be removed to less than .5 grads before the next accumulation can
occur.
3. Repeat steps 1-3 to continue accumulations (up to 99).
Displaying Accumulated Weight and Count.
1. Press and release Over/Under/Next The indicator will alternately display the total accumulated
weight and the number of accumulations for two seconds each. The count is left justified followed by
Acc, and the total weight is right justified.
2. The indicator will continue to alternately display the weight and count for 30 seconds or until
Over/Under/Next is pressed again
Note: The indicator must be displaying gross zero to display totals. An error of “not 00” will display if
weight is not removed.
Clearing accumulated weight and total.
1. With total/count displayed (see Displaying accumulated weight and count above), Press zero.
2. The indicator will display Clr N prompting the operator to not cleat total count and accumulation. If
the totals are to be cleared, toggle to display Clr Y by pressing Over/Under/Next. With the correct
choice displayed, press Program/Enter.
3. The indicator will briefly display Cleared when the accumulator is cleared.
Printing accumulated weight and total.
4. With total/count displayed (see Displaying accumulated weight and count above), press Print.
5. Indicator will display All Y, prompting the operator to print all the individual weighments and the
total accumulation. If only the totals are desired, toggle to display All N by pressing
Over/Under/Next. With the correct choice displayed, press Program/Enter.
6. The indicator will print the accumulated weighments, if selected, followed by the total.
7. After the print has occurred, the indicator will display Clr N prompting the operator to not cleat total
count and accumulation. If the totals are to be cleared, toggle to display Clr Y by pressing
Over/Under/Next. With the correct choice displayed, press Program/Enter.
8. The indicator will briefly display Cleared when the accumulator is cleared.
Deactivating accumulation
To deactivate the accumulation mode, press and hold Tare for 3 seconds. The indicator will display Accoff
briefly to indicate accumulation function has been deactivated.
Accumulation Notes
1. No units switching is allowed if Accumulation is currently activated, or if an accumulation has been
stored and not cleared. The message Nounts will be displayed if Units is pressed.
2. On power up or return from Program mode or Checkweigh Setup mode, if an accumulation has been
stored in units other than Primary Units (PU in config menu), the accumulation units will be
automatically selected.
3. If the accumulation units are no longer enabled on power up or return from Program mode or
Checkweigh Setup mode, the accumulated values will be cleared and Primary Units will be selected.
Peak Hold Weighing
To enable peak hold:
1. Press and hold Over/Under/Next until display indicates Chec.
2. Press Over/Under/Next to display hold.