Hardy Enviro Bench Scales - Manual (Page 12)

Section 3: Installation
12/09 7 0596-0315-01 Rev B
Section 4 Programming Configuration
4.1. OVERALL STEPS
Follow these steps to program the Enviro™ Series instrument.
1. Configure the Enviro™ Series Instrument operating parameters.
2. Calibrate the Enviro™ Series Instrument.
3. Set up the Enviro™ Series Instrument options.
4.2. INTRODUCTION
 The program group is shown and accessed in steps.
 Each program group may be entered and modified, or skipped to the next group.
 At each step, a word or abbreviation displays, indicating the parameter to be set.
 Each step then may be viewed or modified.
 At the end of programming a SAVE prompt will be displayed.
 Press Program/Enter to SAVE and exit or scroll to CANCEL to disregard changes made.
The following is a rendering of the four programming groups. Pressing Over/Under/Next or tare will scroll
through the choices listed. Program/enter will enter the program steps in a particular group. See chart in Sec
4.3 for full details of front panel pushbuttons for programming mode.
SEtuP ConFiG APP CAL donE
SAvE CAncEL