Hangar 9 Pulse XT 60 ARF User Manual
Page 33
33
Note: We install a Dubro inline fuel filter
(DUB340) between the fuel tank and carburetor.
Required Parts
• Fuselage assembly
• Plywood battery tray
• Motor w/hardware
• Motor battery
• #4 washer (4)
• Spinner assembly
• Cowling
• Hook and loop strap (long) (2)
• 8-32 x 3-inch machine screw (4)
• 60-amp electronic speed control
• #4 x 3/8-inch sheet metal screw (2)
• 4-40 x 3/8-inch socket head screw (4)
• 2
7
/
16
-inch (62mm) aluminum standoff (4)
Required Tools and Adhesives
• Hobby knife
• Drill
• Drill bit: 5/32-inch (4mm) • Threadlock
• Hex wrench: 3/32-inch
• Propeller
• Phillips screwdriver: #1
• Propeller reamer
• Rotary tool w/sanding drum
Step 1
Use a hobby knife to remove the plywood from the
openings in the firewall. This will allow cooling air
to pass through the fuselage to keep the electronics
cooler in flight.
Section 5: Electric Motor and Cowling Installation
Section 4: Glow Engine and Cowling Installation