Hangar 9 Pulse XT 60 ARF - Manual (Page 14)

14
 Step 16
Use pliers to make a 90-degree bend at the mark made in
the previous step.
 Step 17
Secure the pushrod wire to the servo horn using a
pushrod connector. The connector will slide onto the wire,
then snap onto the wire under the servo arm.
 Step 18
Use side cutters to trim the pushrod wire so only
1/16-inch (1.5mm) extends beyond the connector.
Hint: Use a flat file to remove any
sharp edges at the end of the wire.
 Step 19
Repeat Steps 8 through 18 for the remaining aileron
servo and linkage.
Section 1: Aileron Servo Installation