Hangar 9 Pulse XT 60 ARF - Manual (Page 21)

21
 Step 12
Use low-tack tape to secure the elevators and rudder in
the neutral position at this time.
 Step 13
Slide a clevis retainer onto each one of the nylon clevises.
Thread a clevis 14 turns onto each of the 27 1 /
2
-inch
(698mm) threaded pushrods.
 Step 14
Slide the pushrod into the hole on the right side of the
fuselage.
 Step 15
Attach the clevis to the center hole of the control horn.
Section 3: Rudder and Elevator Installation