FRITSCH PULVERISETTE 1, Model I premium line - Manual (Page 42)

3. Now use a mallet (k) to gently knock the hex wrench (i), which is
inserted in the cylinder-head screw. The block is pushed by the
dowel pins and is suspended from the cylinder-head screw.
4. Open the lid (1).
5. Hold the released block firmly and unscrew the cylinder-head
screw completely and replace the block.
6. To install the block, simply insert it with the dowel pins in the
holes of the lid (1).
7. Then, re-attach the blocks with the cylinder-head screw to the lid
(1).
6.3 Breaking and grinding in combination with the Disk Mill PULVERISETTE 13 premium
line
To crush coarse material for subsequent use more finely than is possible
with a Jaw Crusher, it is connected to the Disk Mill PULVERISETTE 13 pre‐
mium line.
Crushing with this combination takes place in a single cycle with a feed
size of 95 mm (or 65 mm) up to an average particle size (d
50
) of 0.1 mm.
The Jaw Crusher is placed on a mounting rack (order no.: 43.6000.00)
above the disk mill. The material pre-crushed in the Jaw Crusher slides
along a special chute directly into the funnel of the disk mill.
Accessories
- 42 -