beautypg.com

5 cleaning, 1 housing, 2 cutting chamber – FRITSCH PULVERISETTE 25 User Manual

Page 32: 3 funnels

background image

page 31

PULVERISETTE 25

7. Position the motor cover (14) and screw it on.

8. Reconnect the cutting mill to the mains.

9. Set the main switch (19) on the back of the instrument to I

(ON).

10.The Start button lights green.

11.The instrument is ready for operation.

5 Cleaning

5.1 Housing

The cutting mill can be wiped clean with a damp cloth while
switched off (main switch (19) set to 0 (OFF)).

Do not allow any liquids to flow into the device.

5.2 Cutting chamber

Clean the cutting chamber with a vacuum and brush, possibly
using compressed air.

1. Set the main switch (19) on the back of the instrument to I

(ON).

2. Unlock the latch clamps (13).

3. Open the cover flap (6). This can be lifted out of the hinge for

cleaning.

4. Slowly swing open the upper housing (2) until it rests against

the rubber stop.

5. Clean the cutting chamber.

5.3 Funnels

Clean the funnels with a vacuum and brush, possibly using
compressed air.

5.3.1 Standard Funnel (1)

1. Vacuum out the funnel from below with the grinding chamber

open.

2. Open the funnel lid (21) and clean the funnel from above.