FRITSCH PULVERISETTE 25 - Manual (Page 22)

page 21
PULVERISETTE 25
4.1.4 Inserting / Changing a Rotor
1. Open the cutting mill (see chapter 4.1.1)
2. Pull the rotor (3) out to the front while wearing protective
gloves. If the rotor (3) sticks somewhat, carefully leverage it
out.
3. Clean the tapered mounts for the rotor (3).
4. Clean both tapered mounts (cones) in the cover flap (6) and
on the mount.
5. Slide the rotor (3) onto the rotor mount. Turn it clockwise until
the back side clicks into place on the 4 drive pins (4).