Cub Cadet G730 - Manual (Page 37)

G730 35
Refer to Figure 28
Disassembly
1. Remove all items previously discussed, in
their recommended order.
2. Remove the retaining ring (90).
3. Remove and discard the lip seal (96).
4. Remove the axle shaft (94) in the direction
of arrow.
5. Remove the bearing (95).
NOTE: Remove the bearing from the axle shaft
only if worn or damaged.
Inspection
1. Inspect the axle shaft for wear or damage.
Replace if necessary.
2. Inspect the bearing (95) for wear or damage.
Replace if necessary.
Assembly
1. Assemble items in reverse order of disas-
sembly.
NOTE: To protect the lip seal from possible
damage when installing into the bore
and over the axle shaft, apply a protec-
tive covering over the splines, sharp
corners and/or keyway of the axle shaft
(e.g., cellophane, tape, etc.).
Figure 28, Axle Assembly
AXLE SHAFT (Main Housing)
Configuration “B” instructions listed below are for units with a serial number
on or after 9068YXXXX. For serial numbers before 9068YXXXX see previous
page.
95
94
96
90