beautypg.com

Filter and filter guard, Disassembly, Inspection – Cub Cadet G730 User Manual

Page 12: Assembly

background image

10 G730

191

12

190

FILTER AND FILTER GUARD

Refer to Figure 3

Disassembly

1. Remove the hex head screws (105), and

filter guard (106).

2. Remove the filter (23) and discard.
NOTE: Always replace the filter when preform-

ing any internal maintenance to the

transaxle.

Inspection

1. Inspect all parts for excessive wear or dam-

age. Replace if necessary.

Assembly

1. Reassemble all parts in the reverse order

of disassembly. Refer to “Fluid Change

Procedures,” page 11, steps 3-5 for filter

installation instructions.

2. When tightening the fasteners, refer to the

table on page 20 for the required torque

values.

NOTE: As a general rule, use the low end of

the torque specification on fasteners

when reassembling the unit.

3. Fill transaxle with oil.

Figure 3, Filter and Guard

When refilling the transaxle with oil,

remove the port plug (192), if installed,

and plug (4). Fill until the oil reaches the

lower lip of oil level check port on main

housing.

23

106

105

Units will have installed, the

fitting (5) or the plug (192).

192

Oil Level Check Port Plug (4)