Cub Cadet G730 - Manual (Page 29)

27 G730
INPUT SHAFT
Refer to Figure 19
Disassembly
1. Requires removal of all items beginning on
page 22.
2. Remove the retaining ring (57).
3. Remove the lip seal (56) and discard.
4. Remove the washer (55) and the pump shaft
assembly (52–53).
NOTE: To assist in the removal of the pump
shaft, lightly tap (using a neoprene
head hammer) the shaft from the
charge pump side of housing. Care
should be taken not to damage the
shaft or gerotor running surface.
Remove the bearing from pump shaft
only if worn or damaged.
5. Remove the wire ring retainer (54) and the
bearing (53) from the pump shaft (52).
Inspection
1. Inspect the bearing and input shaft for
wear or damage. Inspect the splines on
the shaft for possible damage.
Replace if necessary.
Figure 19, Input Shaft
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
57
56
55
54
53
52