Cub Cadet G730 - Manual (Page 36)

34 G730
AXLE SHAFT (Main Housing)
Refer to Figure 27
Disassembly
1. Remove all items previously discussed, in
their recommended order.
2. Remove the retaining ring (90).
3. Remove and discard the lip seal (96).
4. Remove the axle shaft (94) in the direction
of arrow.
5. Remove the bearing (95).
Inspection
1. Inspect the axle shaft for wear or damage.
Replace if necessary.
2. Inspect the bearing (95) for wear or damage.
Replace if necessary.
Assembly
1. Assemble items in reverse order of disas-
sembly.
NOTE: To protect the lip seal from possible
damage when installing into the bore
and over the axle shaft, apply a protec-
tive covering over the splines, sharp
corners and/or keyway of the axle shaft
(e.g., cellophane, tape, etc.).
Figure 27, Axle Assembly
Configuration “A” instructions listed below are for units with a serial number
prior to 9068YXXXX. For serial numbers after 9068YXXXX see next page for
Configuration “B” .
90
96
95
94