Cub Cadet G730 - Manual (Page 35)

33 G730
Figure 26, Pump/Motor Cylinder Block Assembly
CYLINDER BLOCKS
Refer to Figure 26
Inspect each component of the cylinder block
assemblies for wear or damage. Inspect the
cylinder blocks’ running surface for scratches
or galling. Replace if necessary.
NOTE: During separation of the cylinder
blocks, take care not to damage the
surfaces of the pistons and block.
Apply a thin coating of oil to all compo-
nents of the cylinder block assemblies
before reassembly.
After reassembling the cylinder block compo-
nents, set aside until ready for installation of
the center section and swashplate. Refer to
pages 28 - 31.
Figure 25, Plug Seal (26)
Refer to Figure 25
In order to gain access to the check plugs (24
& 25), it is necessary to remove the plug seals
(26). This is accomplished by inserting a seal
hook or puller into, and through, one of the
insertion points (rectangular recesses) on the
plug seal, refer to figure 24. After successfully
removing the plug seals, discard and replace
with new seals.
CHECK PLUGS & SEALS
Pistons
Thrust Washers
Cylinder Block
Springs
Insertion Area