beautypg.com

Axle shaft (side housing) – Cub Cadet G730 User Manual

Page 25

background image

G730 23

Figure 14, Axle Assembly

AXLE SHAFT (Side Housing)

Configuration “A” instructions listed below are for units with a serial number

prior to 9068YXXXX. For serial numbers after 9068YXXXX see next page for

Configuration “B”

.

Refer to Figure 14

Disassembly

1. Remove all items previously discussed, in

their recommended order.

2. Remove the retaining ring (90).
3. Remove the lip seal (96) and discard.
4. Remove the axle shaft (94) in the direction

of arrow.

5. Remove the bearing (95).

Inspection

1. Inspect the axle shaft for wear or damage.

Replace if necessary.

2. Inspect the bearing (95) for wear or damage.

Replace if necessary.

Assembly

1. Assemble items in reverse order of disas-

sembly.

NOTE: To protect the lip seal from possible

damage when installing into the bore

and over the axle shaft, apply a protec-

tive covering over the splines, sharp

corners and/or keyway of the axle shaft

(e.g., cellophane, tape, etc.).

95

96

90

94

2