Cub Cadet G730 - Manual (Page 16)

14 G730
Refer to Figure 6
Disassembly
1. Remove the RTN control arm kit by first
removing the spring (147) and Torx head
screw (46). The remaining members of the
assembly can be removed as a single item
– washer (146), unidirectional scissor arm
kit (145), and the control arm (44).
2. Remove the Allen head screw (142), washer
(45), neutral arm (141) and spacer (140).
NOTE: Only remove the seal (41) if damaged
or worn. The seal is not part of the RTN
control arm kit. Refer to “Seal Kit” in the
Items List on page 37.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 20 for the required torque
values.
3. Refer to the RTN adjustments on page
13.
NOTE: As a general rule, use the low end of
the torque specification on fasteners
when reassembling the unit.
RETURN TO NEUTRAL ASSEMBLY
Figure 6, Return to Neutral Assembly
R
efeR to
“R
etuRn to
n
eutRal
S
etting
”
o
n
P
age
13.
41
141
147
142
44
146
145
46
45
140