Cub Cadet G730 - Manual (Page 23)

G730 21
NOTE: It is necessary to remove the G730™
from the vehicle before performing the
repair procedures presented in this
section.
Before starting any disassembly, make
certain that your work area is neat and
clean. Clean the external parts of the
transaxle.
The following procedures are pre-
sented in the order recommended for a
complete tear down of the transaxle.
Do not disassemble the unit any far-
ther than necessary to accomplish the
required repairs.
Reassembly is accomplished by per-
forming the “Assembly” portions of the
procedures. If the unit has been com-
pletely disassembled, a summary of
the assembly procedures, in the order
in which they should occur, is given on
page 36.
Figure 12, G730 Transaxle
TRANSAXLE REMOVAL