Cub Cadet G730 - Manual (Page 17)

G730 15
RETURN TO NEUTRAL/ROS ASSEMBLY
Refer to Figure 7
Disassembly
1. Remove all items previously discussed in
their recommended order.
2. Remove the spring (147).
3. Remove the Torx head screw (46), discard,
and the washer (146).
4. Remove the scissor arm (145), and the RTN
control arm (44).
5. Remove the Hex flange head screw (142),
the bushing (45), the RTN neutral arm (141)
and spacer (140).
Inspection
1. Inspect all parts for wear or damage. Re-
place if necessary.
Assembly
1. Install the spacer (140) and neutral arm
(141).
2. Install the bushing (45) and the hex head
screw (142).
3. Install the control arm (44).
4. Install the RTN scissor arm (145), washer
(146) and Torx head screw (46). Refer to
torque chart on page 15.
5. Install the switch (158) and retainer (156)
over the neutral arm tab (141). Place the
rivet (157) through the switch retainer (156)
and neutral arm (141).
6. Install the RTN spring (147).
7. Press down on the switch retainer tab (156)
to bias it. Ensure that the rivet is seated.
Then set the rivet using a rivet gun.
8. Refer to page 13 for adjusting the RTN as-
sembly.
NOTE: After installing the transaxle on the
vehicle be sure the operator presence
system and the reverse operation
system (ROS) are working properly.
Refer to the operations and mainte-
nance sections in the vehicle owner’s
manual.
Figure 7, Return to Neutral/ROS Assembly
46
146
145
147 157
159
44
142
45
141
140
157
156,158
41