Cub Cadet G730 - Manual (Page 26)

24 G730
Figure 15, Axle Assembly
95
96
90
94
2
AXLE SHAFT (Side Housing)
Configuration “B” instructions listed below are for units with a serial number
on or after 9068YXXXX. For serial numbers before 9068YXXXX see previous
page.
Refer to Figure 15
Disassembly
1. Remove all items previously discussed, in
their recommended order.
2. Remove the retaining ring (90).
3. Remove the lip seal (96) and discard.
4. Remove the axle shaft(94) and bearing(95)
in the direction of arrow.
NOTE: Remove the bearing from the axle shaft
only if worn or damaged.
Inspection
1. Inspect the axle shaft for wear or damage.
Replace if necessary.
2. Inspect the bearing (95) for wear or damage.
Replace if necessary.
Assembly
1. Assemble items in reverse order of disas-
sembly.
NOTE: To protect the lip seal from possible
damage when installing into the bore
and over the axle shaft, apply a protec-
tive covering over the splines, sharp
corners and/or keyway of the axle shaft
(e.g., cellophane, tape, etc.).