Cub Cadet RT 75 - Manual (Page 50)

RT 75
46
Swivel Bracket
To rebuild the swivel assembly:
1. Remove the handle bar assembly, by following the
procedures described in the previous section of this
chapter.
NOTE: It is advisable to rebuild the swivel assembly
on the machine. Having the lower bracket
mounted to the frame provides stability while
torquing the lower nut.
2. Remove the upper jam lock nut from the swivel
assembly, using a 15/16” wrench. See Figure 8.7.
3. Remove the flat washer. See Figure 8.8.
4. Remove the lower nut, using a 15/16” wrench. See
Figure 8.9.
Figure 8.7
upper jam lock nut
Figure 8.8
flat washer
Figure 8.9
lower nut