Cub Cadet RT 75 - Manual (Page 22)

RT 75
18
7. Slide the forward drive belt off of the engine pulley.
8. Loosen the nut and bolt that secures the reverse
idler pulley to the idler bracket, using a pair of 7/16”
wrenches. See Figure 4.3.
9. Slide the reverse belt past the belt guards and off of
the idler pulley.
10. Unhook the reverse idler spring. See Figure 4.4.
11. Unhook the reverse cable Z-fitting from the reverse
idler bracket.
12. Remove the four screws, two on each side, that
secure the front bumper to the frame, using a 1/2”
wrench.
13. Remove the four engine mounting screws, using a
1/2” wrench.
14. Lift the engine off of the tiller and place it in a safe
work area.
NOTE: If replacing the engine, continue to the next
step.
Figure 4.3
reverse idler
pulley
Figure 4.4
Unhook spring
Belts pushed down
Figure 4.5
screws