Cub Cadet RT 75 - Manual (Page 46)

RT 75
42
9. Apply anti-seize to the tine shaft.
10. Installing the assembly.
11. When correctly installed:
• The end of the tine holder with the clevis pin
hole should face towards the transmission.
• The outside tines should curve inward
• The tines should be bolted to the outboard side
of the plate on the tine holder. See Figure 7.9.
12. Insert the tine hood end panel. Secure it with the
center wing nut.
13. Install the side shield. Secure it with the remaining
wing nuts.
14. Test the tiller in a safe area before returning it to
service.
Figure 7.9
clevis pin
Figure 7.10
Side shield
center wing nut