Cub Cadet RT 75 - Manual (Page 37)

Transmission Overhaul
33
Transmission assembly
1. Thoroughly clean the entire transmission housing.
2. Clamp the transmission housing in a soft jawed vice.
3. Make certain all the drive shaft components are
accounted for.
4. Locate both hex flange screws that were securing the
hood bracket to the transmission assembly.
5. Locate two sets of flat washers that would equal
approximately 0.120” in thickness (the thickness of
the hood bracket).
NOTE: Measure the thickness of both washers using a
dial caliper. See Figure 6.16.
6. Install the front snap ring using snap ring pliers.
7. Lubricate and install the front tapered roller bearing
race into the front of the transmission housing. It
should seat up against the front retaining ring. See
Figure 6.17.
NOTE: The front race is installed from inside the transmis-
sion housing.
8. Install a new front oil seal.
9. Place the tine shaft worm gear in the transmission
housing. See Figure 6.18.
Figure 6.16
Dial Caliper
Washers
Figure 6.17
Bearing race
Snap ring
Figure 6.18
Worm gear