Cub Cadet RT 75 User Manual
Page 42
RT 75
38
34.
Secure the rear bearing cap to the transmission assembly with the hex flange screws with the washers used
earlier, using a 1/2” wrench.
NOTE: Tighten the hex screws to a torque of 100 in lbs (11 Nm).
NOTE: Leave the two top screws in place until the sealant has cured. Then they should be removed.
35.
Verify the end play is between 0.005” - 0.015” by repeating step 32a. through step 32e.
36.
Install both of the wheel shaft seals.
37.
Install both of the tine shaft seals.
38.
Fill the transmission with 30 oz (0.9 L) of 85W-140 gear lube.
39.
Install the transmission covers using new gaskets.
40.
Install the transmission in the tiller.
41.
Test run the tiller in a safe area before returning it to service.
See also other documents in the category Cub Cadet Special machinery:
- G1332 (20 pages)
- i1046 (32 pages)
- i1046 (36 pages)
- 54M (28 pages)
- 980 (20 pages)
- 949 (20 pages)
- Time Save (28 pages)
- 990 (24 pages)
- 997 (36 pages)
- V469 (20 pages)
- M48-M60-KW (28 pages)
- 4 Fabricated Deck (36 pages)
- 4 Fabricated Deck (32 pages)
- 6 Fabricated Deck (28 pages)
- 4 Fabricated Deck (32 pages)
- 4 Fabricated Deck (32 pages)
- 6 Fabricated Deck (36 pages)
- 4 Fabricated Deck (32 pages)
- 6 Fabricated Deck (32 pages)
- CC 500 BAT (30 pages)
- CC 22 (20 pages)
- CC 949 (13 pages)
- 33" Wide Area (29 pages)
- Z-Wing (88 pages)
- TANK S Series: Electrical System (9 pages)
- TANK S Series: Hydraulic Drive & Steering System (12 pages)
- TANK S Series: Steering System Adjustments (11 pages)
- 640 (24 pages)
- 640 (20 pages)
- 641 (24 pages)
- 641 (20 pages)
- J466 (32 pages)
- Series C460 (28 pages)
- 435A (24 pages)
- 642 (24 pages)
- 414 (24 pages)
- M465 (28 pages)
- Fun Runner (117 pages)
- 4 x 2 Big Country - Steel Bed (38 pages)
- 4 x 2 Big Country - Poly Bed & Steel Bed (82 pages)
- 4 x 4 Volunteer (328 pages)
- 6 x 4 Big Country (121 pages)
- CC 4BP 32cc (29 pages)
- 2518-48 (60 pages)
- 1525 (39 pages)